Shoof

This unique device has been developed to simplify the tedious job of trimming tails of milking cows. Tail trimming is carried out to reduce faecal and urine contamination of the milker, and to reduce dirt around the rear quarters and udder of the cow. It is recommended that tail trimming is carried out about twice a year to ensure milker safety and highest milk quality. The TailWell Tail Trimmer is secured by way of the chuck shank into any suitable cordless drill of 14 volts or better, and producing approx. 1,000rpm. It is quiet in use, with a smooth and fast cutting action. Trimming takes only 3-4 seconds per tail, and is easily accomplished during milking. The outer blade oscillates over a fixed inner blade, so there is no risk of injury to man or cow. A neck strap is incorporated so the device can be hands-free between cows. Replacement blade sets are available. Lubrication is applied to the blades at the start of operation, and should be re-applied each 80-100 tails. Pre-cutting of the tail switch is not necessary, even if it is very dirty.

Replacement sleeve & cord for Shoof Tail Trimmer.

Key features of the Drill Sleeve and Cord for the Tail Trimmer Drill Attachment:
Replacement part
High quality materials
Strong and durable

Replacement cutter set for Tailwell MK2

Tailwell has only three moving parts. Of these, only one - the self-lubricating sliding-block Rotator Bearing - is subject to any wear.

Pack contains two replacement parts

Research has confirmed that several diseases, including E.coli scours and Joint-ill, find their way into the newborn animal via the umbilical cord. Sprays and dips can also cause problems. These umbilical clamps are the solution. Simply attach as soon as possible after birth. Remove after 24 to 48 hours. Place clamp approximately 5mm from top of umbilical cord. Cut cord below clamp to prevent suckling. Clamps can be disinfected and re-used if desired, or can be left to fall off naturally. Clamps are 65mm long.

Pack of 50 blue clamps

For vehicle entrances to disease-sensitive facilities. This extremely durable mat can be placed so that all vehicles in and out pass over it. Designed to allow all tyres to do a full rotation on the mat.The mat can handle all traffic from small cars, to full-size trucks. The Shoof Vehicle Disinfection Mat is supplied in two parts that are domed together along the centre line for use. There are stainless steel eyelets in the corners for securing to the roadway if required. The road surface must be smooth under the mat. Asphalt is excellent, chip seal is acceptable if it is fine chip. If the road is coarse chip seal, plain gravel or sand, it should be covered with plywood under the mat. Directions for Use To use for the first time, prepare about 40 litres of disinfectant solution in 20-litre jerry cans. Pour slowly on each side of the mat. (When the mat is new it can be slow to take in the solution.) For subsequent daily or twice-daily refilling, apply 20 litres to each side of the mat, or such amount as required.